Heated Loading Arms All WSI loading/unloading arm configurations are available as steam jacketed, or trace heated, or contra heated
PTFE Lined All WSI loading/unloading arm configurations are available with PTFE lining
Drip Bucket and Bucket Hook A hook on the end of the Drop Tube and a bucket to catch product drips
T Deflector A ‘T’ piece fitted to the end of the Drop Tube to deflect the flow as it enters the tank…Top only
Cone Deflector A Cone fitted to the end of the Drop Tube to spread the flow evenly as it enters the tank…Top only
Telescopic Drop Tubes To enable the product to be dispensed in to the tank at the lowest level possible. Also used for continuity between the loading arm and the tank. Manual and powered…Top Only
Drop Tube Handle A manual handle on the Drop Tube for handling the loading arm…Top Only
Bonding Straps A hard wired link across each swivel joint to maintain continuity
Balance Mechanisms Arms are balanced by heavy-duty compression spring with 90° of total movement. Alternative balance mechanisms available are gas strut, counterweight, pneumatic and hydraulic
Ground Verification Monitor An explosion proof electrical control system to continually monitor static charge accumulation in the vehicle. Communicates with the DCS to allow operations to start/carry-on only when the static accumulation is below recommended levels
Rack Monitor Where applicable. An explosion proof electrical control system that continuously monitors the high level liquid sensors in a tank/compartment. In the event of a high level signal or a sensor failure the monitor shuts down the loading operation
Breakaway Device In the event of a vehicle drive away the Breakaway device with shear and seal the connection to the loading arm and to the vehicle
Remote Shut Down Spring closed, air open shut off valve activated remotely
Parallel Device Maintains the Drop Tube is a parallel position regardless of the position of the Primary Tube.
Control Valves/Isolation Valves Manual or automated control valve or isolation valve mounted before the inlet to the loading arm or mounted within the loading arm to control flow or act as an isolation valve
Purging Points or system To allow an inert product to clear out any remaining product in the arm
Parking Adapter A device to retain the loading arm in it’s parked position
Parking Adapter and Drip Collection A Parking funnel attached to the loading rake with a drain pipe to a central collection point
Position Sensor Electrical explosion proof proximity or limit switch (s) to advise the position of the loading arm
High Level Detection Electrical explosion proof sensor to advise when the liquid has reached a predetermined point…Top only
Vapour Recovery
Vapour plate and vapour hose Mounted on the Drop Tube of an open dome fill operation to divert most of the displaced vapours from the tank away from the loading area. Usually includes High Level Detection…Top only
Vapour Cone and vapour hose Mounted on the Drop Tube of an open dome fill operation to divert the majority of displaced vapours from the tank away from the loading area. Always includes High Level Detection…Top only
Piggy Back Vapour Hose For Tight Fill operations, a vapour hose is carried by the loading arm and used to divert all the displaced vapours away from the loading area
Hold Down An assembly to provide a physical lock for when the arm is in the lowered and loading/unloading position. Recommended on Variable Reach Loading Arms…Top only
Check Valve Mounted in the Primary to prevent product being drawn back in through the loading arm. Also acts as a pilfering deterrent
Leak Detection System Monitors each swivel joint for signs of primary seal failure to give early warning of a potential leak to atmosphere
Stand Post: A fabricated stand to which the loading/unloading arm is attached. Most large Top Loading Arms and some Bottom Loading Arms come with a Stand Post
Outboard End Connections to suit the application: Hammer Union, Dry- Break/Dry-Gas Couplers and Adapters, Cam and Grove Couplers and Adapters, Lap Flange connections